Tesla Model S: Brakes
- Brake Rotor - Front - LH (Remove and Replace)
- Brake Rotor - Rear - LH (Remove and Replace)
- Brake Caliper - Front - LH (Remove and Replace)
- Brake Caliper - Rear - LH (Remove and Replace)
- Brake Pads - Front - Set (Remove and Replace)
- Brake Pads - Rear - Set (Remove and Replace)
- Shield - Dust - Brake - Front - LH (Remove and Replace)
- Shield - Dust - Brake - Rear - LH (Remove and Replace)
- Shield - Dust - Brake - Front - 2nd Generation (Retrofit)
- Master Cylinder and Reservoir Assembly (Remove and Install)
- Master Cylinder (Remove and Replace)
- Brake Hose - Flexible - Front - LH (Remove and Replace)
- Brake Hose - Flexible - Rear - LH (Remove and Replace)
- Bleed Procedure - One Caliper (Remove and Replace)
- Bleed Procedure - System (Remove and Replace)
- Vacuum Brake Booster Assembly (Remove and Replace)
- Vacuum Pump (Remove and Replace)
- Bracket - Vacuum Pump (Remove and Replace)
- Reservoir - Master Cylinder (Remove and Replace)
- Brake Lines - Booster to ABS (Dual Motor) (RHD) (Remove and Replace)
- Rear Park Brake Caliper Release
- Park Brake Caliper - Release - Harness Tool - Through Calipers
- Park Brake Caliper - Release - Harness Tool - Through ECU
- Brake Caliper - Rear - Park Brake - LH (Remove and Replace)
- Brake Pads - Park Brake - Set (Remove and Replace)
- Brake Pads - Park Brake - Burnishing
- ABS Modulator Assembly (Remove and Replace)
- Sensor - Wheel Speed - ABS - Front - LH (Remove and Replace)
- Sensor - Wheel Speed - ABS - Rear - LH (Remove and Replace)
- Brake Sensor Cluster - ESC (Remove and Replace)
READ NEXT:
Brake Rotor - Front - LH (Remove and Replace)
Warning: If the vehicle
has air suspension, activate "Jack" mode on the touchscreen before
raising and supporting the vehicle.
Special tool(s) required for this procedure:
Brake Rotor - Rear - LH (Remove and Replace)
Warning: If the vehicle
has air suspension, activate "Jack" mode on the touchscreen before
raising and supporting the vehicle.
Special tool(s) required for this procedure:
Brake Caliper - Front - LH (Remove and Replace)
Warning: If
the vehicle has air suspension, activate "Jack" mode on the
touchscreen before raising and supporting the vehicle.
Removal
Remove the rear underhood apron
SEE MORE:
USB Drive Requirements for
Recording Videos
NOTE: For saving Sentry Mode and Dashcam footage,
Tesla recommends using the USB port located in the
glovebox. Doing so increases security and minimizes
power consumption.
One or more features on your Model S requires the use
of a flash drive (for example, Dashcam, Sentry Mode and
Track Mode (i
Motor - Seat Height - Driver's Seat (Remove and Replace)
Removal
Power the seat fully upward, away from the floor.
Remove the driver's seat outer side cover (refer to procedure).
Disconnect the seat height motor connector and harness.
Remove the outboard nuts (x3) that secure the seat height motor
to the seat (torque 8 Nm).
© 2019-2026 Copyright www.tesms.org
