Tesla Model S: Four Wheel Alignment Check
Tesla Model S (2012-2026) Service Manual / Suspension / Four Wheel Alignment Check
READ NEXT:
Four Wheel Alignment Check - Preparation
Note: This procedure
is not specific to a particular alignment machine. Follow the
alignment equipment manufacturer's instructions for additional
information and safety instructions.
Alignment Check
Raise the alignment platform until it is clear
of all 4 rack locks.
Lower the alignment platform onto the rack
locks and ensure that it is level.
Secure all 4 alignment
Four Wheel Alignment - Check and Adjust
Note: This procedure is not specific to a particular alignment
machine. Follow the alignment equipment manufacturer's instructions for
additional information and safety instructions.
Special to
SEE MORE:
Pipe - High Pressure - Charge Port (Remove and Replace)
Removal
Recover refrigerant from the vehicle (refer to procedure)
Remove underhood storage unit (refer to procedure)
Remove nut securing pipe retaining plate to evaporator TXV
(torque 22 Nm).
Remove bolt securing A/C pipe bracket to cross-brace (torque 6
Nm).
Suspension - Rear - Check Torque
Warning: If the vehicle has air suspension, activate "Jack"
mode on the touchscreen before raising and supporting the vehicle.
Check the tightening torque of the following fasteners:
Caution: Only fully tighten suspension nuts and bolts when the vehicle
is on a 4-post lift and the suspension
© 2019-2026 Copyright www.tesms.org
