Tesla Model S: Windows
Opening and Closing
Press down on a switch to lower the associated window. Window switches operate at two levels:
- To lower a window fully, press the switch all the way down and immediately release.
- To lower a window partially, press the switch gently and release when the window is where you want it.
Similarly, pull a switch to raise the associated window:
- To raise a window fully, pull the switch all the way up and immediately release.
- To raise a window partially, pull the switch gently and release when the window is where you want it.
If a window is left open unintentionally, Model S can send a notification to the mobile app (touch Controls > Locks > Car Left Open Notification, then choose Doors & Windows).
You can also enable Close Windows on Lock by touching Controls > Locks > Close Windows on Lock. When enabled, your vehicle automatically closes the windows when Model S locks.
NOTE: See Cold Weather Best Practices for information on preparing windows for cold weather.
CAUTION: To avoid damage, windows automatically lower slightly when you open or close a door. If you manually raise a window when the door is open, ensure it is slightly lowered before closing the door.
WARNING: Before closing a window, it is the driver's responsibility to ensure that all occupants, especially children, do not have any body parts extended through the window's opening. Failure to do so can cause serious injury.
Locking Rear Windows
To prevent passengers from using the rear window switches, touch Controls > Locks > Window Lock. To unlock the rear windows, touch Window Lock again.
WARNING: To ensure safety, it is recommended that you lock the rear window switches whenever children are seated in the rear seats.
WARNING: Never leave children unattended in Model S.
READ NEXT:
Rear Trunk
Opening
To open the rear trunk, ensure Model S is in Park, then
do one of the following:
Touch Controls > Trunk on the touchscreen.
Double-click the rear trunk button on the key fob.
Touch the
Opening
To open the front trunk, ensure Model S is in Park, and
then do one of the following before pulling the hood
open:
Touch Controls > Frunk on the touchscreen.
Double-click the front trunk butto
SEE MORE:
Assembly - Panel - Wrapped - LH (Remove and Replace)
Removal
Release the clips (x10) that secure the wrapped panel trim.
Note: Components have been removed in this graphic
to aid clarity.
Remove the LH wrapped panel trim.
Battery Coolant Pump 2 (Remove and Replace)
Warning: If the 12V power supply is disconnected, do
not attempt to open any doors with door glass in closed position.
Failure to follow this instruction could result in door glass
shatter.
Note: Before disconnecting the 12V power supply,
ensure that the driver's door window i
