Tesla Model S: External Charging Connectors
Tesla Model S (2012-2026) Service Manual / External Charging Connectors
- Handle and Cable Assembly - 40A Wall Connector (Remove and Replace)
- Handle and Cable Assembly - 80A Wall Connector (Remove and Replace)
- 200A Fuses - Wall Connector (Remove and Replace)
- 200A Fuses - Wall Connector (Remove and Replace) - Removal
- 200A Fuses - Wall Connector (Remove and Replace) - Installation
- Firmware Update - CHAdeMO Charging Adapter
READ NEXT:
Handle and Cable Assembly - 40A Wall Connector (Remove and Replace)
Note: This procedure describes how to remove and replace
the 40A Wall Connector handle and cable assembly. For instructions
on how to remove and replace the 80A Wall Connector handle and cable
Handle and Cable Assembly - 80A Wall Connector (Remove and Replace)
Note: This procedure describes how to remove and replace
the 80A Wall Connector handle and cable assembly. For instructions
on how to remove and replace the 40A Wall Connector handle and cable
SEE MORE:
Horn - 1st Generation (Remove and Replace)
Removal
Remove the front underhood apron (refer to procedure).
Remove the bolt that secures the horn to the bracket (torque 8
Nm).
Move the connector covers aside and disconnect the horn
connectors (x2).
Rem
Jacking and Lifting
Jacking Procedure
Follow the steps below to lift Model S. Ensure that any
non-Tesla repair facility is aware of these lifting points.
1. Position Model S centrally between the lift posts.
2. If your Model S is equipped with air suspension, it
automatically self-levels, even when power is off (see
© 2019-2026 Copyright www.tesms.org
