Tesla Model S: Wiper Blades and Washer Jets
READ NEXT:
Periodically clean the edge of the wiper blades and
check the rubber for cracks, splits, and roughness. If
damaged, replace the blade immediately to prevent
damage to the glass and improve visibili
For optimum performance, replace the wiper blades at
least once a year. Replacement blades must meet the
following criteria:
The blade on the driver's side must be 26 inches (650
mm) long and 20
SEE MORE:
The HV battery alignment rods assist in aligning the HV battery during
installation.
Note: This tool is intended to be used by 2 technicians.
To use the alignment rods:
Position the table under the vehicle until the bolt holes in the battery
and vehicle are roughly aligned. Do not lo
Removal
Remove the hood latch cover (refer to procedure).
Remove the nuts (x2) that secure the latch assembly to the
crossmember (torque 16 Nm).
Release the latch assembly from the studs, then lower and
disconnect the harness connector.
Disconnect the hood release cable