Tesla Model S: Pivot Lock - Seat back - 2nd Row Seat - RH (Remove and Replace)
Removal
- Remove rear seat back rest assembly (refer to procedure)
- Remove E-clip securing pivot lock.
- Slide pivot lock from backrest frame.
Installation
Installation procedure is the reverse of removal.
READ NEXT:
Removal
Remove Rear LH seat back rest assembly (refer to procedure)
Spread nose of pivot sleeve and remove from LH seat backrest.
Removal
Open the liftgate.
Fold down the third row seats.
Caution: Take care not to damage component(s).
Caution: Protect the interior trim from possi
SEE MORE:
During charging, the charge port light pulses green, and
the touchscreen displays real-time charging status. The
frequency at which the green charge port light pulses
slows down as the charge level approaches full. When
charging is complete, the light stops pulsing and is solid
green.
NOTE: If
Removal
Remove IP carrier (refer to procedure)
Disconnect duct temperature sensor harness connector.
Remove screw securing duct to HVAC assembly and position duct
aside (torque 1 Nm).
Disconnect actuator harness